TYPE MTS7 - FLANGED MACHINE TOOL SEALS
IMPORTANT: The basic purpose of MTS7 seals is that they do not require an additional housing. It may be removed easily for inspection or replacement. These seals are highly recommended for use on machinery where the simplification of replacing shaft seals is a necessity. The ideal rotating surface should be 63 RC hardness or better. The surface should be lapped. This diameter represents the seal contact surface that will be provided for the MTS7 seal face to run against.
GENERAL
APPLICATION INFORMATION
The Type MTS7 seal will provide exceptional
maintenance free service under severest of operational requirements.
It offers positive oil retention means in heavy machine tools,
gear boxes and other types of industrial equipment.
OPERATIONAL
CAPABILITIES
|
Pressure-
|
0
to 10 psi standard design and application.
Higher pressure design available. |
|
Temperature-
|
0
- 200°F, Rubber coated fabric diaphragm
|
|
0
- 300°F, Teflon coated glass fabric diaphragm
|
|
|
Speed-
|
5,000
FPM at face of seal - carbon face
|
STANDARD DESIGN SERIES
|
VARIATION
NUMBER
(flanged housing) |
Face
|
Diaphragm
Material
|
|
MTS7-000-01
|
Bronze
|
Rubber
coated cotton fabric
|
|
MTS7-000-02
|
Carbon
|
Rubber
coated cotton fabric
|
|
MTS7-000-03
|
Bronze
|
Teflon
coated glass fabric
|
|
MTS7-000-04
|
Carbon
|
Teflon
coated glass fabric
|
|
NTI
SEALS SPEC CONTROL NUMBER
|
||
|
MS1
|
000
|
00
|
|
Design
Series
|
Shaft
Size
|
Spec
Control Suffix*
|
*Operational
data required:
A. Fluid to be sealed
B. Pressure to be sealed
C. Rotating surface mating (describe bearing race, shaft shoulder)
D. Desired face dimension (to match rotating mating face)
INSTALLATION
Rotating mating face must be lapped
flat and smooth - 6-8 RMS and 3-4 helium light bands flat. Suggested
materials include close grained cast iron, 52100 hardened steel
or equivalent.
GASKET
Will be furnished with seal on request.
BOLTS
Will be furnished with seal on request.